Tractor Talk Discussion Board |
Re: Re: Fergi voltage
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Keith on February 11, 2004 at 00:28:33 from (205.188.208.73):
In Reply to: Re: Fergi voltage posted by Wayne on February 10, 2004 at 20:00:11:
I did a 12 volt conversion on a ford 640 in 1980 sold it to a friend , still has the original starter on it to this day. 6 volt starter has a lot heavier windings, turns a lot faster. Therefore tractor should start quicker. I remember coverting a 1953 ford 3/4 ford pickup to overhead valve engine 292 CI in 1971 left the 6 volt starter on it. That winter got down to 20 below here, the only thing in the area that would start was my 1953 ford pickup. Had do a lot of running around for all the neighbors untill weather warmed up a little. Never again got bad word about my old ford truck.In all the years that I had the 1953 ford ,it never failed to start. my input. 4 what it is worth
Follow Ups:
Home
| Forums
Today's Featured Article -
Engine Valves - Some Helpful Information - by Staff. Intake - On the intake stroke the piston moves doward, sucking in carburized fuel through the open intake valve. Exhaust valve is closed. Compression - With both the intake and exhaust valves closed, the pistons upward stroke compresses or squeezes the fuel into the combustion chamber. Firing - Ignited by the spark, the compressed fuel explodes and forces the piston downward on its power stroke. Intake and exhaust valves are closed. Exhaust valves and seats are exp
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|