Re: Hough H30 Power Loss Problem

Posted by Bill on February 04, 2004 at 08:56:30 from (67.30.1.19):

In Reply to: Hough H30 Power Loss Problem posted by Emery on September 08, 2003 at 05:12:20:

Not sure what you mean by transfer case. Transmission or torque converter? You need to get the fluid level to the dip stick mark on the transmission before you can do any testing. There are three tests to check before running a stall test to determine the cause of the loss of power. Run tractor to warm oil 150F minimum. Run RPM to 1000 and read the clutch pressure on service gauge attached to center bolt on transmission main valve. If it is less than 170 psi you cannot run the stall test because the clutch will slip and burn the clutch plates. If the clutch pressure is OK than insure converter pressure is at least 50 psi read at the hi pressure port of the pump to pressure regulator and the lube pressure is at leat 10 psi read at the oil supply tap on the front of the 1st gear clutch pack on the front of the transmission. If all of run stall test to see what the result is.

Follow Ups:

Post A Followup Name: E-Mail: Subject: Re: Re: Hough H30 Power Loss Problem Comments: Optional Link URL: Link Title: Optional Image URL: Email Notification: If you check this box, email will be sent to you whenever someone replies to this message. Your email address must be entered above to receive notification. This notification will be cancelled automatically after 2 weeks.

TRACTOR PARTS	TRACTOR MANUALS

We sell tractor parts!  We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]