Tractor Talk Discussion Board |
Re: Re: Re: Re: couldn't pick up the bale
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Joe on February 01, 2004 at 11:20:24 from (66.243.138.48):
In Reply to: Re: Re: Re: couldn't pick up the bale posted by Mark on February 01, 2004 at 06:34:48:
Mark, thanks for the reply. I think I may have found the problem. When I checked the service manual, it says that I should have 2300-2400 psi and the test lift should be at least 1250 lbs. It also shows that the system being overloaded is the most likely cause. Anyway, I pulled the top plate off the reservoir and the fluid is a nice yellow milky color. There are water bubbles on the components. So the oil got water in it somehow. I'll be draining the system, replacing some hoses while it is empty, cleaning the filter screen and refilling with some good ol' Hy-Tran. Then I'm going to find some more weights for the front ends and try to keep from blowing out that bad back tire. Golly gee willicker, I do love to mess around with this old junk. Ah, well, still cheaper than new stuff. By the way, the folks around here sell hay by the bale, but I can calculate tonnage, so I buy where I get the best deal. The farmer that I buy these monster bales from charges $40 a bale. If it weighs what I think it does, that is $40-55 per ton. I buy square bales from a rancher who makes a 70 lb average bale. A ton from him costs about $85 when I'm paying $3-3.50 a bale. Some other folks around here charge the same for a 40-50 lb bale which puts the per ton price up around $110. I work hard for my money, I buy where I get value. Thanks again, Joe
Follow Ups:
Home
| Forums
Today's Featured Article -
The Nuts and Bolts of Fasteners - Part 2 - by Curtis Von Fange. In our previous article we discussed capscrews, bolts, and nuts along with their relative hardness and thread sizes. In this segment we will finish up on our fasteners and then work with ways to keep them from loosening up in the field. Capscrews, bolts and nuts are not the only means of holding two parts together. When dealing with thinner metals like sheet tin, a long bolt and
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|