Tractor Talk Discussion Board |
Re: repair of ci flat belt pulley
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by MT Pockets on January 25, 2004 at 13:14:08 from (64.12.96.236):
In Reply to: repair of ci flat belt pulley posted by rhudson on January 25, 2004 at 11:25:42:
The answer is yes. A piece of quarter inch material the same width as the pulley and longer than you think you need is what you need to start with. Clamp one end of the patch on unbroken part of the pulley. Heat with rosrbud until cherry red and bend to fit the curviture of the pulley to start. This arc will be a little too straight.Put it over something vee shaped and hammer the inside from one end to the other, periodically fitting it to the side of the pulley to see when you have it just right. Grind breaks on the pullet square and bevel them. Mark the patch to fit and cut it. Bevel both ends of the patch.(About 35 degrees would be good on all bevels. no more than forty five degrees.) If you know how to braze, go for it. If you don't know how, get someone who is experienced and is good at it. This is not the place to practice. Do not arc weld this under any circumstances except maybe four tiny places with 7018 for fit up. Good luck. MT. Pockets.
Follow Ups:
Home
| Forums
Today's Featured Article -
Choosin, Mounting and Using a Bush Hog Type Mower - by Francis Robinson. Looking around at my new neighbors, most of whom are city raised and have recently acquired their first mini-farms of five to fifteen acres and also from reading questions ask at various discussion sites on the web it is frighteningly apparent that a great many guys (and a few gals) are learning by trial and error and mostly error how to use a very dangerous piece of farm equipment. It is also very apparent that these folks are getting a lot of very poor and often very dangerous advice fro
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|