Tractor Talk Discussion Board |
Re: Re: Re: over flowing radiator
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Greywolf on January 22, 2004 at 07:12:06 from (209.23.142.41):
In Reply to: Re: Re: over flowing radiator posted by FARMIN RED on January 22, 2004 at 05:57:28:
Like david stated...engine compression leaking into the cooling system. Cooling systems are designed to operate somewhere around 7-12 (give or take exact numbers don't really matter for explanation purposes)pounds of pressure. The pressure created by the combustion process is much much greater than that. If the head gasket is comprimised in the area around the cooling passages, high pressure always goes towards low pressure. The pressure created in the cooling system is then higher than designed, the relief feature of the radiator cap releases, pushing coolant along with the excess air out through the overflow tube. An easy method of checking this is to take off the radiator cap on a cold running engine. Watch for bubbles forming in the coolant, the amount and size of the bubble will indicate the severity of a leak. Also, after the engine has been shut down....coolant will also go into the combustion chamber of the affected cylinder if the cooling system is kept closed. A major leak will leave coolant, a minor one the coolant will evaporate.
Follow Ups:
Home
| Forums
Today's Featured Article -
The Nuts and Bolts of Fasteners - Part 2 - by Curtis Von Fange. In our previous article we discussed capscrews, bolts, and nuts along with their relative hardness and thread sizes. In this segment we will finish up on our fasteners and then work with ways to keep them from loosening up in the field. Capscrews, bolts and nuts are not the only means of holding two parts together. When dealing with thinner metals like sheet tin, a long bolt and
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|