|
Tractor Talk Discussion Board |
Re: Re: Re: 186 Hydro
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by John on January 20, 2004 at 08:48:52 from (67.35.232.48):
In Reply to: Re: Re: 186 Hydro posted by Dr.EVIL on January 20, 2004 at 08:00:45:
Like I said I do not know this machine so I am guessing but by the way you describe it I would say.
It has two small tanks but is using them connect by a sealed system to make it one tank with no switching valve. If it has two sending units like you think then they would be hooked together with gauge getting half the resistance from one sending unit and the other half from the other. Have never seen a set up like this but any thing is possible.
One question I would have is does gauge work from full to empty on a working system? What I mean is does it stick on full for a long time then start working OR maybe work correctly at first but motor will still run long after gauge says empty. It may be using the lower tank as a reserve unit.
To truly know if it has one or two sending units you would need a wiring diagram. To check to see if problem is in gauge or sending unit see my other post as this will work on any type setup. John
Follow Ups:
Home
| Forums
Today's Featured Article -
Engine Valves - Some Helpful Information - by Staff. Intake - On the intake stroke the piston moves doward, sucking in carburized fuel through the open intake valve. Exhaust valve is closed. Compression - With both the intake and exhaust valves closed, the pistons upward stroke compresses or squeezes the fuel into the combustion chamber. Firing - Ignited by the spark, the compressed fuel explodes and forces the piston downward on its power stroke. Intake and exhaust valves are closed. Exhaust valves and seats are exp
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|
