Tractor Talk Discussion Board |
Re: 806 Shifting Problems
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by E J on January 12, 2004 at 07:49:39 from (67.31.156.13):
In Reply to: 806 Shifting Problems posted by B B on January 12, 2004 at 03:30:16:
Yes I have changed 706,806,& two 1206s over too 56&66 shifts.The last one I bought from salvage yard was 400.00 with every thing needed.It would help to have a service manual.THese can be wore also pins & linkage rollers,detents which you can buy new still.Cowleing behind fuel tank take off,platte form off ,range deck plate off,left side on trans plate where reverse shifter fork is .Helps to take right steering colume suport off park lever etc.& linkage and use 56 suport instead of 06 other wise you have to do some grinding on the 06 suport,may loose your hyd.out let I ground mine out for the uprigtt shift shaft to fit.Make sure you leave the shift collar on the bottom speed shaft other wise it will fall down in trans.don"t want that.You can cut the cowling to fit the new shift pattern.Also theirs a bushing you will have to drive out up by the shift levers and replace with 56or66 bushing.Clear as mud right you can do it.
Follow Ups:
Home
| Forums
Today's Featured Article -
History of the Nuffield Tractor - by Anthony West. The Nuffield tractor story started in early 1945. The British government still reeling from the effects of the war on the economy, approached the Nuffield organization to see if they would design and build an "ALL NEW" British built wheeled tractor, suitable for both British and world farming.
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|