|
Tractor Talk Discussion Board |
starter/solenoid
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Gus on January 01, 2004 at 07:09:55 from (205.188.208.73):
Tried to start my JD450B after it sat for 2 months. Turned over a few times, battery died. Charged it hit the starter button, nothing. Put the charger on 200 amp boost, nothing.It has a key and starter button. When I hit the button, amp guage shows a draw. Put the jump cable directly on the solenoid with good ground, nothing. Took the solenoid off, took the cap off, cleaned the copper all up, wd40-ed everything. Putsolenoid back on, hit the button, nothing. Guage on dash still shows draw when I hit the button. Lights work so I,m pretty sure battery connections are good. Strter is fairly new (200 hours ago) It's a real bi%^h to change and expensive so I'm hoping it's something else. Would the amp guage show a draw if the starter button was bad and not the solenoid? Wouldn't the sloenoid at least click if it was OK and the starter was bad? Thanks for any input. Gus
Follow Ups:
Home
| Forums
Today's Featured Article -
The Nuts and Bolts of Fasteners - Part 2 - by Curtis Von Fange. In our previous article we discussed capscrews, bolts, and nuts along with their relative hardness and thread sizes. In this segment we will finish up on our fasteners and then work with ways to keep them from loosening up in the field. Capscrews, bolts and nuts are not the only means of holding two parts together. When dealing with thinner metals like sheet tin, a long bolt and
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|
