Tractor Talk Discussion Board |
Re: Sears
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by John K on December 30, 2003 at 22:05:25 from (66.222.132.230):
In Reply to: Sears posted by Jerry on December 30, 2003 at 16:00:57:
I have three open end wrenches 1/2 x 9/16 bought at different times. The first one is slim and of pro grade, the second double in thickness home grade and the third is almost double in thickness of the second and is of hammer grade. The last one feels like it is a piece of metal that could be used for beating with. Here in Central Alberta most people that I know now buy Master Craft Professenal sold by Canadian Tire. Lifetime warrenty and look and feel like Snap On. Was even told that the parts in the rachets are interchangable. They are about the same price or a bit less then Crapman tools.
Follow Ups:
Home
| Forums
Today's Featured Article -
Third Brush Generators - by Chris Pratt. While I love straightening sheet metal, cleaning, and painting old tractors, I use every excuse to avoid working on the on the electrics. I find the whole process sheer mystery. I have picked up and attempted to read every auto and farm electrics book with no improvement in the situation. They all seem to start with a chapter entitled "Theory of Electricity". After a few paragraphs I usually close the book and go back to banging out dents. A good friend and I were recently discussing our tractor electrical systems when he stated "I figure it all comes back to applying Ohms Law". At this point
... [Read Article]
Latest Ad:
John Deere B 1943
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|