Tractor Talk Discussion Board |
Re: Re: backhoe repair
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by ShepFL on December 23, 2003 at 10:27:49 from (155.14.26.22):
In Reply to: Re: backhoe repair posted by marlowe on December 22, 2003 at 17:29:27:
Ditto to Marlowe's comments. I could not afford the hardened pins. I use mild steel. Have a friend that has lathe that turned them down for me. I doubt I will where them out as the backhoe is rarely used anymore. Also if just a little slop in the boom bucket is it really that critical? In my experience I have found for most of my dirt work it is not critical. Now that said, if I was working paid construction I would be more concerned about overswing and the like due to potential hazards; people, phone lines, water mains etc. As to reboring or relining I would take it in to have that work done due to critical nature and stress on the steel. All I did was replace worn pins on a MF 50C TLB for general farm work i.e. stump removal, drainage ditches, swales etc. FWIW
Follow Ups:
Home
| Forums
Today's Featured Article -
Engine Valves - Some Helpful Information - by Staff. Intake - On the intake stroke the piston moves doward, sucking in carburized fuel through the open intake valve. Exhaust valve is closed. Compression - With both the intake and exhaust valves closed, the pistons upward stroke compresses or squeezes the fuel into the combustion chamber. Firing - Ignited by the spark, the compressed fuel explodes and forces the piston downward on its power stroke. Intake and exhaust valves are closed. Exhaust valves and seats are exp
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|