Tractor Talk Discussion Board |
Re: Re: Home made snow plow
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by old on November 10, 2003 at 19:51:06 from (63.189.40.78):
In Reply to: Re: Home made snow plow posted by RayP(MI) on November 10, 2003 at 19:07:26:
I use this on an 801 ford with front end loader. I took and old boiler tank and cut two pieces out of it 5'X2' and made a V plow, at the bottom if it I took a piece of U iron to fit the bottom lip of the bucket and welded it to the V with 2 angle iron pieces slanted in words make it easy to line it up with the bucket and on top of the V made a piece that goes back to the top of the bucket and a piece of U iron there also. when its up to the bucket I put a couple chains around it and bommer it tight and off I go. works very well and the V keeps it from pushing the front of the tractor to one side or the other. Makeing the V is the hardest part of the welding/cutting. E-mail me if you would like more and maybe I'll even get some picture of it. If enough people ask.
Follow Ups:
Home
| Forums
Today's Featured Article -
Engine Valves - Some Helpful Information - by Staff. Intake - On the intake stroke the piston moves doward, sucking in carburized fuel through the open intake valve. Exhaust valve is closed. Compression - With both the intake and exhaust valves closed, the pistons upward stroke compresses or squeezes the fuel into the combustion chamber. Firing - Ignited by the spark, the compressed fuel explodes and forces the piston downward on its power stroke. Intake and exhaust valves are closed. Exhaust valves and seats are exp
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|