Tractor Talk Discussion Board |
Re: O/T for you science buffs
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Chris on November 07, 2003 at 10:56:44 from (69.34.246.51):
In Reply to: O/T for you science buffs posted by Jonathan on November 07, 2003 at 08:40:49:
I did a report in school on this-long time ago. In the 1940s the military did extensive research to see if "falling" bullets could cause injury. They found that if the bullet was actually fired perfectly straight up it would eventually stop, reverse and gravity would pull it down all the while maintaining its gyro effect that keeps a bullet stabilized. Therefore the bullet would fall tail first causing enough drag to slow it down below fatal velocity(I bet it would really hurt though!)They decided if the bullet fell point first it would have enough velocity to cause injury but not death with the exception of a direct head shot. Your teacher was quoting what is known as urban legend, science proves otherwise.
Follow Ups:
Home
| Forums
Today's Featured Article -
Third Brush Generators - by Chris Pratt. While I love straightening sheet metal, cleaning, and painting old tractors, I use every excuse to avoid working on the on the electrics. I find the whole process sheer mystery. I have picked up and attempted to read every auto and farm electrics book with no improvement in the situation. They all seem to start with a chapter entitled "Theory of Electricity". After a few paragraphs I usually close the book and go back to banging out dents. A good friend and I were recently discussing our tractor electrical systems when he stated "I figure it all comes back to applying Ohms Law". At this point
... [Read Article]
Latest Ad:
John Deere B 1943
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|