Tractor Talk Discussion Board |
Re: Ether
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by thurlow on October 27, 2003 at 10:16:27 from (208.128.241.29):
In Reply to: Ether posted by Allan on October 27, 2003 at 06:03:04:
Well, Allan, I've followed the replies to your post, the ones seven or eight posts down and the ones that appear on here just like clock-work every week or so. Nothing but anecdotal evidence from me. Been using the stuff better than 45 years; ten diesels currently here on the place; all of them except the Cummins in the Dodge occasionally get a "whiff" of ether; they've all got block heaters which are used when possible, but occasionally don't happen to have 10 mile long extension cord in truck; rather use ether than "grind" on the starter. Two oldest tractors are early model 4020s, which were bought new; no telling at the cans (cases) of ether that have been put through them; both have better than 15,000 hours on 'em; one of them has never had the head off of it; don't know how long they'll last, but I'm sure it would have been longer if they hadn't had all that ether put through 'em.......
Follow Ups:
Home
| Forums
Today's Featured Article -
The Nuts and Bolts of Fasteners - Part 2 - by Curtis Von Fange. In our previous article we discussed capscrews, bolts, and nuts along with their relative hardness and thread sizes. In this segment we will finish up on our fasteners and then work with ways to keep them from loosening up in the field. Capscrews, bolts and nuts are not the only means of holding two parts together. When dealing with thinner metals like sheet tin, a long bolt and
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|