|
Tractor Talk Discussion Board |
Desperate: I Need Help In A Hurry!! (Off-Topic)
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Allan on October 25, 2003 at 17:17:45 from (148.63.132.164):
Hi Guys, I hope someone out there can help me. Without going into blow by blow details, the problem is this: I'm putting a center pivot on one of my places which has been in flood irrigation since 1948. It already has a well and the underground pipe is already in place. I pulled the well in about 1980 or so, and put in a Western Land Roller 4-stage set of bowls. These replaced the original 2-stage bowls, which had been in operation since the well was drilled in the early '50s by my Dad. The young man who is renting the place tells me that the people who are installing the pivot want to first test the well (which is fine with me) and then pull it and install a set of 4-stage bowls. My question is this: Is there a difference in bowls? Is there a "pressure" bowl vs an open discharge bowl? I think the well already has the proper bowls, because we had to turn the thing down because it was pumping way too much water to handle(1000 gal) at that time (1980). Can someone help? Anyone? Thanks, Allan
Follow Ups:
Home
| Forums
Today's Featured Article -
The Nuts and Bolts of Fasteners - Part 2 - by Curtis Von Fange. In our previous article we discussed capscrews, bolts, and nuts along with their relative hardness and thread sizes. In this segment we will finish up on our fasteners and then work with ways to keep them from loosening up in the field. Capscrews, bolts and nuts are not the only means of holding two parts together. When dealing with thinner metals like sheet tin, a long bolt and
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|
