Tractor Talk Discussion Board |
Re: Re: Re: horsepower and torque
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Rod F. on October 05, 2003 at 05:52:22 from (142.177.78.184):
In Reply to: Re: Re: horsepower and torque posted by Jerry/MT on October 04, 2003 at 21:30:06:
Indy is right. Dynos do give a figure of output hp, but it is a calculated figure, not a measured figure. Dyno's measure torque and speed, and from that can calculate HP, and torque rise. You are correct though, that there are shaft dynos, which most of us are familiar with, as well as chassis dynos. Torque can be measured in ft-lb's or in-lb's. The latter simply being 12 times the value of the former. Hp=(torque*RPM)/constant. The constant when using ft-lb is 5252, and the constant when using in-lb is 63025. Note that it is 12 times that of 5252. Those are the figures I was taught anyway. Rod
Follow Ups:
Home
| Forums
Today's Featured Article -
The Day Mom Drove the 8N - by Brian Browning. My Dad was wanting to put in a garden but couldn't operate the 8N and handle the old horse drawn plow he had found and rigged up to use with the tractor. Well, he decided to go get Mom out of the house and have her drive the tractor while he walked behind the plow. You got to understand that while my Mom is a hard worker who will always help whenever she can... she had never operated farm machinery before that day. Dad got her out there, explained how the clutch was the same as in our o
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|