Tractor Talk Discussion Board |
Re: Re: Why Not?
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by evielboweviel on October 04, 2003 at 06:17:27 from (67.26.7.153):
In Reply to: Re: Why Not? posted by Dieselrider on October 04, 2003 at 05:09:59:
your a little confused. very simply in generic terms, the pump pumps oil stored in a tank to a valve(s) then back to the tank. when a valve is operated then oil goes out to the cylinder and extends it out (ram cylinders) when the valve is released then the oil has no where to go and the ram stops at that position. when the valve is moved to the opposite position then the oil is allowed to return to the tank allowing the ram to retract. the pump pumps oil stored in a tank to a valve(s) then back to the tank. when a valve is operated then oil goes out to the cylinder and extends it out (double acting cylinders) also oil is returned from the other side of the piston to the tank. when the valve is released then the oil has no where to go and the cylinder stops at that position. when the valve is moved to the opposite position then the oil goes out to the other side of the cylinder pushing the piston back in retracting the cylinder.oil is also allowed to return to the tank from the bottom side of the cylinder. FOR MORE AND BETTER INFO GO HERE http://www.adtdl.army.mil/cgi-bin/atdl.dll/fm/5-499/toc.htm
Follow Ups:
Home
| Forums
Today's Featured Article -
The Nuts and Bolts of Fasteners - Part 2 - by Curtis Von Fange. In our previous article we discussed capscrews, bolts, and nuts along with their relative hardness and thread sizes. In this segment we will finish up on our fasteners and then work with ways to keep them from loosening up in the field. Capscrews, bolts and nuts are not the only means of holding two parts together. When dealing with thinner metals like sheet tin, a long bolt and
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|