Tractor Talk Discussion Board |
Re: Re: Belt pulley and belt care
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Rod (NH) on September 02, 2003 at 06:24:26 from (12.148.160.138):
In Reply to: Re: Belt pulley and belt care posted by Les...fortunate on September 02, 2003 at 02:54:56:
Hi Les, Ah, the trial and error method :o). Yes, it works if you are knowledgeable about where you want to be. But if you have never used a cordwood saw before, how do get that feel that it is not running as good as it should and you need to make some kind of change? Throttle changes are easy if you are reasonably close to begin with. However, if you don't have the driven pulley and are looking to get one, how big should it be? I suppose you could copy another installation that you know works well, but that's a little risky if the tractors are different. Trial and error works but it can be a frustrating and expensive experience sometimes. Better to know definitely that you are headed in the right direction. You are more likely to be satisfied that way. Must be the engineer in me talking. Got that tractor running yet? Hope all is progressing well on that front. Rod
Follow Ups:
Home
| Forums
Today's Featured Article -
The Nuts and Bolts of Fasteners - Part 2 - by Curtis Von Fange. In our previous article we discussed capscrews, bolts, and nuts along with their relative hardness and thread sizes. In this segment we will finish up on our fasteners and then work with ways to keep them from loosening up in the field. Capscrews, bolts and nuts are not the only means of holding two parts together. When dealing with thinner metals like sheet tin, a long bolt and
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|