Tractor Talk Discussion Board |
Re: tips on hyd cylinder rebuild
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Jailkeeper on August 15, 2003 at 22:08:48 from (216.174.160.141):
In Reply to: tips on hyd cylinder rebuild posted by rod on August 15, 2003 at 17:38:58:
You'll have to buy new packing kits for the cylinders. When you get them apart, make sure you check the pistons and cyl. barrels for grooves, and the cyl. shaft should be free of rust, nicks and scratches. The chrome shaft is probably the most important part, even a small nick will cause a considerable loss of oil over time. As far as putting the packing in, the worst ones are the inside seals in the gland (where the shaft slides in and out). The seals are usually very stiff and require a lot of patience and manipulating to get in the groove. I have soaked seals in hot oil a few times just to make them more flexible and easier to work with. You will probably have to use a couple of screwdrivers to pry the seals in place, just be careful not to damage them. Good luck.
Follow Ups:
Home
| Forums
Today's Featured Article -
History of the Nuffield Tractor - by Anthony West. The Nuffield tractor story started in early 1945. The British government still reeling from the effects of the war on the economy, approached the Nuffield organization to see if they would design and build an "ALL NEW" British built wheeled tractor, suitable for both British and world farming.
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|