Tractor Talk Discussion Board |
Re: Help! International 175 Swather
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Bob Thielen on August 12, 2003 at 19:50:40 from (199.199.182.101):
In Reply to: Help! International 175 Swather posted by cam on July 04, 1999 at 19:08:38:
Have you checked the clutches? There is a clutch that drives each side. They work very similar to a clutch in a manual transmission. If the clutch pads are worn excessively or the internal tension springs are broken or worn out the clutch pads will slip. If you look between each clutch you will find the throwout bearings attached to hte linkage from the stearing levers. These bearings will push against the clutch fingers to release the clutch when you pull back on the stearing levers. When you release the stearing levers the throw-out bearings will release the clutch fingers and the clutch pads will contact the clutch plate to drive the swather forward. The pads should be about 1/4" to 3/8" thick. One other possibility. If the clutch plate or pads are oil or grease impregnated they will slip also. This can happen if you overgrease and some gets onto the pads or plates. Hope this helps.
Follow Ups:
Home
| Forums
Today's Featured Article -
The Nuts and Bolts of Fasteners - Part 2 - by Curtis Von Fange. In our previous article we discussed capscrews, bolts, and nuts along with their relative hardness and thread sizes. In this segment we will finish up on our fasteners and then work with ways to keep them from loosening up in the field. Capscrews, bolts and nuts are not the only means of holding two parts together. When dealing with thinner metals like sheet tin, a long bolt and
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|