Tractor Talk Discussion Board |
Re: Darn Square nuts/bolts!
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Okla/Kans Bill on July 28, 2003 at 15:23:02 from (209.240.198.61):
In Reply to: Darn Square nuts/bolts! posted by G. L. Perry on July 27, 2003 at 20:20:31:
Never had a square head bolt round off. I dont usually change them back to square if I need to. I do try to reuse them if at all possible. Rusty, U might remember I was workin on my 30. Thought I needed to replace the rear main bearing. Turned out (Lord thank you) that it was only that every bolt in the bell housing holding it to the engione was finger tight, or loose. But before I found that out, I was going to replace the bearing which ment I had to pull the engine. I broke the left front square headed bolt as it was rusted ti 1/2 its size in the rail. I repaced it with an all thread with a nut on botyh sides. I will replace it with a square head bolt when my dealer gets on in Aug he says. That is about the only square head bolts on it.
Follow Ups:
Home
| Forums
Today's Featured Article -
Women and Tractors - More Views From the Farmer's Wife - by Teri Burkholder. The top ten reasons why the judges wouldn't let you participate in the stock antique tractor pull: Hey, this is stock! It came with that V8 in it! That "R" on my tires stands for "really old" not radial! Blue gas? We thought it was a pretty color! What wire hooked to my throttle?
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|