Tractor Talk Discussion Board |
Re: Please help me set up my Brush Hog!
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Eldon on July 17, 2003 at 08:17:06 from (209.240.198.61):
In Reply to: Please help me set up my Brush Hog! posted by Tim on July 16, 2003 at 20:11:15:
If your tractor doesn't have a "hold" position on the hydraulics, you will have to use chains to keep the front of the mower at the right height. Use the tail wheel to set the height that you want to cut. Your top link should have some sort of slack built in. If it doesn't and you go through a ditch you can bend things up.....you can use a chain if the mower doesn't have a built-in slide or pivot mount. Also check to see that the slip clutch is working (if it has one), or if not, that there is a soft "shear" bolt where the pto shaft attaches to the gear box.
Follow Ups:
Home
| Forums
Today's Featured Article -
Talk of the Town: Repairin a Gas Tank - by Staff. This interesting discussion is from the Tool Talk Discussion Forum. Remember that safety is your first priority - make sure you know what you are doing before attempting a potentially dangerous activity!
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|