Tractor Talk Discussion Board |
Re: o.t. worst roads
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Scott Williams on June 25, 2003 at 08:31:08 from (66.82.9.24):
In Reply to: o.t. worst roads posted by rustyfarmall on June 24, 2003 at 06:00:08:
Don't remember what the # was, but there was a road between Leigh, NE, and Omaha, NE, that almost destroyed my new pickup back in 2000. Told my buddy after about 50 miles of the return trip, that we'd leave the D*@# tractor out there if the roads didn't get any better. Almost bit my tounge off a couple of times. Hehe.......after we got the tractor weighted on the trailer correctly, roads weren't so bad after all. I run a trucking company, so I have heard about all the rough roads all over the country, but I will agree with the post below that some of NC's interstates are horrible. I didn't even pull a trailer with me last weekend, and I-40 between Raleigh and Winston Salem skeered the heck out of me. I HATE THOSE CEMENT BARRIERS!!! I just wonder why they feel the need to put them right on the yellow line. No room for error at all!!
Follow Ups:
Home
| Forums
Today's Featured Article -
Third Brush Generators - by Chris Pratt. While I love straightening sheet metal, cleaning, and painting old tractors, I use every excuse to avoid working on the on the electrics. I find the whole process sheer mystery. I have picked up and attempted to read every auto and farm electrics book with no improvement in the situation. They all seem to start with a chapter entitled "Theory of Electricity". After a few paragraphs I usually close the book and go back to banging out dents. A good friend and I were recently discussing our tractor electrical systems when he stated "I figure it all comes back to applying Ohms Law". At this point
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|