Tractor Talk Discussion Board |
Re: irrigation water hooked to pto
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Bob Clark on June 03, 2003 at 17:59:23 from (24.154.96.80):
In Reply to: irrigation water hooked to pto posted by dennis on June 01, 2003 at 11:36:12:
Used a Case 1370 back in 79-81 to irrigate corn pulling from a large stream (probably couldn't do that today). Pump was 600 gpm at 140 psi for a hose reel traveler. It is definately not the same as regular field work. We ran at about 1900 rpm, probably at about 95 hp for 36 to 72 hours at a time. Murphy gauges are a must. A small oil or water leak is fatal. Had to design a heat exchanger. We ran 50 feet of copper tubing connected to the heater bypass line soaking in half a 50 gallon barrel that had a 1/4 line from the irrigation pump bleeding about 5 gallon per minute of cool creek water into it. Good luck.
Follow Ups:
Home
| Forums
Today's Featured Article -
Third Brush Generators - by Chris Pratt. While I love straightening sheet metal, cleaning, and painting old tractors, I use every excuse to avoid working on the on the electrics. I find the whole process sheer mystery. I have picked up and attempted to read every auto and farm electrics book with no improvement in the situation. They all seem to start with a chapter entitled "Theory of Electricity". After a few paragraphs I usually close the book and go back to banging out dents. A good friend and I were recently discussing our tractor electrical systems when he stated "I figure it all comes back to applying Ohms Law". At this point
... [Read Article]
Latest Ad:
John Deere B 1943
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|