Tractor Talk Discussion Board |
Re: Re: pto over shaft coupler
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by paul on May 24, 2003 at 23:08:54 from (209.23.145.20):
In Reply to: Re: pto over shaft coupler posted by Smitty on May 24, 2003 at 16:28:44:
If that one were sheared, it would fall off, but it would not rotate. He must have parts busted inside it. Really cheaper to just buy a new one, then to fool around with whatever model he has. Likely cost more to track down parts, if any available. You would have to remove this pin, to get the ORC off, then take it apart & find out what is broken inside, probably worn out dogs and/or springs, would need to be rebuild & put back together. Simple parts, but where would you find them? --->Paul
Follow Ups:
Home
| Forums
Today's Featured Article -
Women and Tractors - More Views From the Farmer's Wife - by Teri Burkholder. The top ten reasons why the judges wouldn't let you participate in the stock antique tractor pull: Hey, this is stock! It came with that V8 in it! That "R" on my tires stands for "really old" not radial! Blue gas? We thought it was a pretty color! What wire hooked to my throttle?
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|