Tractor Talk Discussion Board |
Re: Help , My J D 5020 broke
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by G-MAN on May 22, 2003 at 07:39:34 from (206.106.139.74):
In Reply to: Help , My J D 5020 broke posted by stan on May 21, 2003 at 14:54:19:
EPC shows four different axle lengths, so make sure you get the right one when hunting used parts. Some, if not all, of the axles were also common to the 6030, which also gives you some more avenues to search when looking for a good used one. Make sure the used axle hasn't had the bearing spin on the shaft. Also get ahold of the proper service manual to make sure you properly establish axle bearing preload. A hoist and the proper tools will make that job much easier, as you're working with some big iron there. You'll probably want to borrow or build some sort of a stand to set the axle in to keep the final drive in a vertical position during reassembly. Your local dealer would probably lend you one, especially if you purchase your bearings and seals there.
Follow Ups:
Home
| Forums
Today's Featured Article -
Talk of the Town: The Saga of Grandpa's Tractor - by The following saga is from the Tractor Talk Discussion Forum. Someone. The saga starts with the following message: Hey guys I have a decision to make. I know what you all will probably suggest and it will probably agree with me way down inside, but here it is. I have a picture blown up and framed in my "tractor room" of a Farmall M. It was my Grandpa's tractor, of which whom I never got to meet. He froze to death getting this tractor out of the barn to pull a truck out of the ditch before I was born. Anyway my dad and aunt had to sell it at the auction,
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|