Welcome! Please use the navigational links to explore our website.
PartsASAP LogoCompany Logo (800) 853-2651

Shop Now

   Allis Chalmers Case Farmall IH Ford 8N,9N,2N Ford
   Ferguson John Deere Massey Ferguson Minn. Moline Oliver
 
Marketplace
Classified Ads
Photo Ads
Tractor Parts
Salvage

Community
Discussion Forums
Project Journals
Your Stories
Events Calendar
Hauling Schedule

Galleries
Tractor Photos
Implement Photos
Vintage Photos
Help Identify
Parts & Pieces
Stuck & Troubled
Vintage Ads
Community Album
Photo Ad Archives

Research & Info
Articles
Tractor Registry
Tip of the Day
Safety Cartoons
Tractor Values
Serial Numbers
Tune-Up Guide
Paint Codes
List Prices
Production Nbrs
Tune-Up Specs
Torque Values
3-Point Specs
Glossary

Miscellaneous
Tractor Games
Just For Kids
Virtual Show
Museum Guide
Memorial Page
Feedback Form

Yesterday's Tractors Facebook Page

  
Tractor Talk Discussion Board

Re: low compression, 8n, will she run?


[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]

Posted by Bryan on May 19, 2003 at 09:43:12 from (207.171.93.45):

In Reply to: low compression, 8n, will she run? posted by Bryan on May 16, 2003 at 06:54:32:

Well, I got the ignition problems solved on Saturday-(Before I began working on that I put 2 oz. of MMO in each cylinder, at 2pm, as suggested). The ignition switch bad, replaced, now I have 6.2 volts to coil (but is this to much or fine?) Battery was 6.5 volts.New batt.

Then no spark at coil??!!- took time to check for bad ground at distribtor- terminal ground good- continuity to engine and to points on condensor side. But no continuity from breaker arm to point- so that means when points are closed, there is no current flow- I surmised. Plate that stuff mounted on all rusty- took point and condensor, off, took plate off; wire wheeled rust off and cleaned body of dist. Then put new point assembly in and gapped. Wow! spark at coil and plug wires - spark white to blue colored. (First time I have replaced dist. parts! I'm used to electronic auto stuff) I was excited, was now 6pm (MMO soaked 4 hours) and wanted to try starting her. I put a little gas in each cylinder, plugs in, cranked, just a pop or two, then ran out of time. Rigged a one gallong mower gas tank up to feed the carb. Had to go home. I think there is alot of crap in the engine as I pulled one plug (all 4 new) before leaving and it had black , oily stuff on it.
What should I try to do to start this low compression beast? Pull start it without gas on, but spark on to clean out engine (oils/carbon.)?? The old plugs that were in it, appeared more carboned, than oil burned, they were black and sooty. What do you guys think I should do to try and start it. Has good starter and battery to spin her over. Also , I should maybe check timing, to make sure ignition perfect ( never done this on 8n so back to the manual).
Thanks for reading and suggestions.
Bryan
Minnesota


Follow Ups:




Post A Followup

:
:

: Re: Re: low compression, 8n, will she run?

:

:

:

:

: If you check this box, email will be sent to you whenever someone replies to this message. Your email address must be entered above to receive notification. This notification will be cancelled automatically after 2 weeks.


TRACTOR PARTS TRACTOR MANUALS
We sell tractor parts!  We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]

Home  |  Forums


Today's Featured Article - Women and Tractors - More Views From the Farmer's Wife - by Teri Burkholder. The top ten reasons why the judges wouldn't let you participate in the stock antique tractor pull: Hey, this is stock! It came with that V8 in it! That "R" on my tires stands for "really old" not radial! Blue gas? We thought it was a pretty color! What wire hooked to my throttle? ... [Read Article]

Latest Ad: Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request [More Ads]

Copyright © 1997-2024 Yesterday's Tractor Co.

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy

TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters

Website Accessibility Policy