Tractor Talk Discussion Board |
WD-45 3pt conversion
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by randall r baldauf on May 06, 2003 at 05:17:38 from (209.206.209.65):
I got on this page back in the fall and asked for ideas on how to build (NOT BUY) a 3pt conversion for a WD-45. Dennis Springer was good enough to send me some photos on his conversion for a D-17, and was working on one for a WD-45. I e-mailed him with my question but the mail was returned. Any way I got the lower end built and mounted but had questions on the mount for the top link. I took a 1/2" ubolt around the shaft for the lift arms and put it through a piece of 1/2" plate and was going to weld two ears to that for the top link but I don't like the way it rotates as you put the lift arms up and down. Anyone have any experence with mounting the top link? Does it matter if it rotates? Thanks in advance. Randy
Follow Ups:
Home
| Forums
Today's Featured Article -
The Day Mom Drove the 8N - by Brian Browning. My Dad was wanting to put in a garden but couldn't operate the 8N and handle the old horse drawn plow he had found and rigged up to use with the tractor. Well, he decided to go get Mom out of the house and have her drive the tractor while he walked behind the plow. You got to understand that while my Mom is a hard worker who will always help whenever she can... she had never operated farm machinery before that day. Dad got her out there, explained how the clutch was the same as in our o
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|