Tractor Talk Discussion Board |
Re: What's gonna happen if I use the 1000 PTO
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by rednekelmo on May 03, 2003 at 00:20:31 from (205.188.209.105):
In Reply to: What's gonna happen if I use the 1000 PTO posted by SkipShifter on May 02, 2003 at 21:17:16:
well it's likely that you will have to run the motor at about 1000rpm or so to make your 1000 shaft turn close to 540 (just guessing engine speed is about 1900 rpm for 540 pto speed) so now the question is do you have the hp to pull the shreader at just above idle? perhaps you can find a 1000 gearbox for the shreader.now this said I did spend a summer mowing with a 540 mower hooked to the 1000 shaft just went up a few gears and ran the motor at about 1100rpm. no one died and nothing was destroyed I just used common sense.
Follow Ups:
Home
| Forums
Today's Featured Article -
Women and Tractors - More Views From the Farmer's Wife - by Teri Burkholder. The top ten reasons why the judges wouldn't let you participate in the stock antique tractor pull: Hey, this is stock! It came with that V8 in it! That "R" on my tires stands for "really old" not radial! Blue gas? We thought it was a pretty color! What wire hooked to my throttle?
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|