Tractor Talk Discussion Board |
Re: which bearing has the most travel??
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by David on April 28, 2003 at 04:27:57 from (130.209.6.43):
In Reply to: which bearing has the most travel?? posted by Terry on April 27, 2003 at 21:21:29:
Big ends usually wear quicker but that's because of the loading they have on them and has nothing to do with "travel". Think we need to define what's meant by travel. RPM is identical but distance rolled is dependant on bearing circumference. (Which is also why small diameter tyres wear out faster than large ones.) Also, the bigger the diameter of the bearing, the faster the bearing surfaces will travel relative to one another for any given RPM. So if big ends have a bigger diameter than mains, the surfaces will be travelling faster even although the RPM is the same. -- probably. I'm getting confused now too.
Follow Ups:
Home
| Forums
Today's Featured Article -
Third Brush Generators - by Chris Pratt. While I love straightening sheet metal, cleaning, and painting old tractors, I use every excuse to avoid working on the on the electrics. I find the whole process sheer mystery. I have picked up and attempted to read every auto and farm electrics book with no improvement in the situation. They all seem to start with a chapter entitled "Theory of Electricity". After a few paragraphs I usually close the book and go back to banging out dents. A good friend and I were recently discussing our tractor electrical systems when he stated "I figure it all comes back to applying Ohms Law". At this point
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|