Tractor Talk Discussion Board |
Re: Question: replace /repair Allis-Chalmers B front wheel spindle
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by wdTom on April 23, 2003 at 17:16:14 from (155.212.222.130):
In Reply to: Question: replace /repair Allis-Chalmers B front wheel spindle posted by robert m. rottman on April 22, 2003 at 08:39:29:
I would think it could be straightened with a press and a little time. Machine shop job if you don't have a hydraulic press. As for the wear, I would think it could be built up with spraying matal on similar to repairing a crankshaft. I don't know the cost though. Then you would have to have it machined down to size again. The only other way out of this is to find a used one. Maybe difficult as wide adjustable front ends are probably mostly in use because of the desireability of this option.
Follow Ups:
Home
| Forums
Today's Featured Article -
Women and Tractors - More Views From the Farmer's Wife - by Teri Burkholder. The top ten reasons why the judges wouldn't let you participate in the stock antique tractor pull: Hey, this is stock! It came with that V8 in it! That "R" on my tires stands for "really old" not radial! Blue gas? We thought it was a pretty color! What wire hooked to my throttle?
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|