Tractor Talk Discussion Board |
Re: Where to place axels on a flat deck trailer ???
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by kydavid on April 13, 2003 at 18:12:01 from (152.163.188.71):
In Reply to: Where to place axels on a flat deck trailer ??? posted by Alberta Mike on April 12, 2003 at 07:25:47:
Like you, I have observed that a lot of manufactorers place axles at various locations in relation to the center. I have a 20'+5 dovetail and a 30' straight. Both have tandem 7500# axles/single tires. The 20' has the axles 80% back while the 30 has axles 2/3. The 20' pulls as hard as the 30 even though it weighs a lot less. More of the towed weight is on the towing vehicle, proportionally. It does behave a lot better loaded, feels like I have a lot more control. 20' cattle trailer is also set up 1/3-2/3 and even though it weighs within 400# empty of the 20' flat it pulls like it sdoesn't weigh anything compaired to the flat. The 20' flat also puts a lot of load on the front brakes of the towing vehicle.
Follow Ups:
Home
| Forums
Today's Featured Article -
Women and Tractors - More Views From the Farmer's Wife - by Teri Burkholder. The top ten reasons why the judges wouldn't let you participate in the stock antique tractor pull: Hey, this is stock! It came with that V8 in it! That "R" on my tires stands for "really old" not radial! Blue gas? We thought it was a pretty color! What wire hooked to my throttle?
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|