|
Tractor Talk Discussion Board |
Flushing crud from auxiliary hydraulic system
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Patrick Bennett on March 26, 2003 at 11:50:05 from (4.36.98.2):
I loaned my MF with front end loader to someone.
When I got it back, the front end loader hydraulics was very erratic in operation.
When I dropped the filter shell I found white goo everywhere, and the clogged filter full of the same white goo was lying at the bottom of the outer shell I had removed. The spring which is supposed to go under the filter to hold it up to its connections was missing.
The person who I loaned my tractor to has a pressure washer which they like to use a lot. I cautioned them beforehand about the system breather and pointed it out to them. To be SURE they got NO water anywhere near it.
Evidently they did get water into the system, which created the white goo and clogged the system. So they just dropped the filter, and never said a word to me about what they had done. When I told them later about what I had found, their answer was to stop speaking to me. Family!!!
Also, they ran it down into a shell/sand slurry mixture, so that it covered the cylinder seals. Should I replace these also, and if so, how big a job is this?
Now I would like to properly repair my MF.
What should I use to flush out the system before putting it back into use. I am afraid of using the wrong thing and damaging the seals.
Any help will be greatly appreciated. Thanks!
Follow Ups:
Home
| Forums
Today's Featured Article -
The Day Mom Drove the 8N - by Brian Browning. My Dad was wanting to put in a garden but couldn't operate the 8N and handle the old horse drawn plow he had found and rigged up to use with the tractor. Well, he decided to go get Mom out of the house and have her drive the tractor while he walked behind the plow. You got to understand that while my Mom is a hard worker who will always help whenever she can... she had never operated farm machinery before that day. Dad got her out there, explained how the clutch was the same as in our o
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|
