Tractor Talk Discussion Board |
Re: Re: Re: Sharpening Bushhog Blades?
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by mikeinmo on March 23, 2003 at 20:16:23 from (208.31.189.198):
In Reply to: Re: Re: Sharpening Bushhog Blades? posted by Rich (VA) on March 23, 2003 at 17:28:55:
You are welcome. I prefer the DeWalt variety of 4" angle grinders, but thats just my preference. I agree with Unimog, I'm pretty sure all bush hog blades are replaceable. They can become bent if abused and would need replacing. Also after years of re-sharpening they can get to a point where there is nothing left to sharpen. Many farmers in our area just keep pulling a bush hog and never check the blades to see if they are sharp. We usually sharpen ours once a year, or if we notice it isn't cutting as well as it should. Keep them sharp and it does a better job and requires less power.
Follow Ups:
Home
| Forums
Today's Featured Article -
Restoration Story: 1951 Farmall H - by The Red (John Fritz). I have been a collector of Farmall tractors since 1990 when I first obtained part of the family farm in Eastern Indiana. My current collection includes a 1938 F20, 1945 H, 1946 H, and the recently purchased 1951 H. This article will focus on what I encountered and what I did to bring the 1951 NEAR DEATH Farmall H back to life.
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|