Tractor Talk Discussion Board |
Re: Repair of 806/826 pto system
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Gary on February 22, 2003 at 06:28:31 from (152.163.188.71):
In Reply to: Repair of 806/826 pto system posted by Vern on February 21, 2003 at 16:25:07:
The usual problem I have seen with them was reving the engine wide open, then engaging the pto, causing a terrific amount of slipping and shock to the parts before the piece of equipment gets moving at the pto rate. The proper way is tpo run the engine at as near idle,as possible, engage the pto, then, increase the rpm. The manual will show that these PTO unitd operster )fit) a number of different size tractors and the change is handled by adjusting the hydraulic pressure, accomplished by the control rod adjustment.
Follow Ups:
Home
| Forums
Today's Featured Article -
Women and Tractors - More Views From the Farmer's Wife - by Teri Burkholder. The top ten reasons why the judges wouldn't let you participate in the stock antique tractor pull: Hey, this is stock! It came with that V8 in it! That "R" on my tires stands for "really old" not radial! Blue gas? We thought it was a pretty color! What wire hooked to my throttle?
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|