Tractor Talk Discussion Board |
Re: Re: Re: tune up specs
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Gary on February 18, 2003 at 18:29:56 from (205.188.209.109):
In Reply to: Re: Re: tune up specs posted by Lou on February 18, 2003 at 17:03:02:
The timing point is in the bottom of the flywheel housing inside the hole. There will be a a top dead center mark. If youy have not removed your distributor, you can pull the cap and see when your rotor points toward # 1 cylinder. You will be close then to finding the mark. If you have removed the distributor, you will need to find out of you are top dead center on compression or exhaust. You will remove # 1 spark plug to determine this. When you have the pointer lined up, loosen your mounting bolts, rotate the distributor housing IN THE DIRECTION THEROTOR TURNS. until the points have closed. Turn the switch on and just barely , gentlt rotate the distributor back the other way until the exact instant thepoints open. You may have todo this several times to getit just right. Take your time and get it right. Lock it down with the bolts and the timing is set. Good luck.
Follow Ups:
Home
| Forums
Today's Featured Article -
Women and Tractors - More Views From the Farmer's Wife - by Teri Burkholder. The top ten reasons why the judges wouldn't let you participate in the stock antique tractor pull: Hey, this is stock! It came with that V8 in it! That "R" on my tires stands for "really old" not radial! Blue gas? We thought it was a pretty color! What wire hooked to my throttle?
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|