Tractor Talk Discussion Board |
Re: New shop
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by evielboweviel on February 11, 2003 at 16:29:43 from (204.32.70.107):
In Reply to: New shop posted by Dave on February 11, 2003 at 15:14:56:
add to george's comments: 1" foam insulation under concrete 2" foil faced foam sidewalls and 6" fiberglass 2" foil faced foam on roof and as much fiberglass as will fit. mixture of lights flourscent for light, incadesant for color hot water heat in floor 2x2x1/4 angle iron at all door ways to protect concrete edge. 2 1/2 x 2 1/2 x 3/8 angle down center of shop both ways and steel plates 12"x6"x1" or bigger imbeded in concrete with anchors(angle iron welded under makes good standoff and weld rebar to it). all steel grounded together and ground stub raised up by welder for ground clamp to clamp on.
Follow Ups:
Home
| Forums
Today's Featured Article -
Ford N-Series Transmission/Hydraulic Fluid - The Full Story - by Llamas. The transmission fluid in an “N”:-series tractor lubricates the transmission, differential, rear wheel bearings, PTO and hydraulic pump drive, and it also cats as the working fluid for the hydraulic lift. In 9N/2N models, it also lubricates the steering sector and shaft system. The owner’s manual for the 9N and 2N models specified the use of only two fluids. They were STRAIGHT MINERAL OIL SAE 90 (above freezing) and
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|