Tractor Talk Discussion Board |
Re: Backhoe pump help
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Joe (Wa) on February 01, 2003 at 20:28:54 from (198.133.237.130):
In Reply to: Backhoe pump help posted by Don H on January 31, 2003 at 20:39:33:
Hi Don, I have an ARPS model 90 backhoe on a Case 311b. PTO pump is Prince HC-PTO-2A, 11.4 gpm, wt 36# hanging on the pto stub with no support for last 12 years. The pto bearings are taper roller type (single row). I don't know anything about Ford tractors so this is just my 2¢. Check your bearing type, if taper roller, especially double row, you should be ok. Consider making a simple bracket to support the pump wt if in doubt. Per Greg's post high gpm equals heat, whether you're useing it or not, as it passes through normal valve, bypass, relief restrictions. Case 311b PTO hp 30. Ave backhoe op hp 20-25. Arps mod 90 backhoe same spec as 8600 @ Amerequip site except max hyd psi is 1900 vice 2550. http://www.amerequip.com/products.htm
Follow Ups:
Home
| Forums
Today's Featured Article -
Choosin, Mounting and Using a Bush Hog Type Mower - by Francis Robinson. Looking around at my new neighbors, most of whom are city raised and have recently acquired their first mini-farms of five to fifteen acres and also from reading questions ask at various discussion sites on the web it is frighteningly apparent that a great many guys (and a few gals) are learning by trial and error and mostly error how to use a very dangerous piece of farm equipment. It is also very apparent that these folks are getting a lot of very poor and often very dangerous advice fro
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|