Tractor Talk Discussion Board |
Re: Farmall M carburator
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by John (SC) on January 29, 2003 at 16:41:34 from (206.74.216.162):
In Reply to: Farmall M carburator posted by Farmall Daddy on January 29, 2003 at 16:01:57:
A couple of things come to mind,Is the float moving freely in the carb,you can check this by flipping the assembled carb over and you should hear the float moving around,if not them my guess would be the pin for the float or the peice the pin goes through is worn.If the float is out,shake the float and listen for gas inside of it.Last thing,barring a proper adjustment,did you put the gasket back on the needle and seat assembly for the float and are you 100% sure that there isnt trash in your line that could,by coincedence, be hanging the float open?
Follow Ups:
Home
| Forums
Today's Featured Article -
Third Brush Generators - by Chris Pratt. While I love straightening sheet metal, cleaning, and painting old tractors, I use every excuse to avoid working on the on the electrics. I find the whole process sheer mystery. I have picked up and attempted to read every auto and farm electrics book with no improvement in the situation. They all seem to start with a chapter entitled "Theory of Electricity". After a few paragraphs I usually close the book and go back to banging out dents. A good friend and I were recently discussing our tractor electrical systems when he stated "I figure it all comes back to applying Ohms Law". At this point
... [Read Article]
Latest Ad:
John Deere B 1943
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|