Tractor Talk Discussion Board |
Clutch replacement
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Bus Driver on January 27, 2003 at 17:28:22 from (65.165.152.93):
Due to time not available and no heat in my shop, I took my larger diesel tractor to a dealer for clutch replacement. The pressure plate is a heavy cast iron one with balance holes drilled at the edge. I went by to check on the job and the disassembly is complete and fortunately needs only new clutch plates- the pressure plate (which he is adjusting) and throwout bearing are fine as is. I am feeling good about the fellow working on my tractor. Before removing the pressure plate, he used an aerosol to spray (bright orange) the pressure plate and flywheel at one place to insure reassembly with the parts "timed" exactly as originally. If I do any more clutches myself, I will use the same technique.
Follow Ups:
Home
| Forums
Today's Featured Article -
The Niagra View Mobile - Powered by a 1959 Ford Tractor - by Mark Massey. In 1959 the Niagara Frontier Transit Inc. of Buffalo, New York designed and built six Viewmobiles for the Niagara Frontier Sightseeing Inc. for use as a sightseeing ride at the Niagara Falls State Park, Niagara Falls, New York, powered by a 1959 Ford 611 Tractor.
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|