Tractor Talk Discussion Board |
Re: Re: Re: Re: cylinder ridge
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by G Taylor...doing it right on January 23, 2003 at 06:05:41 from (64.10.143.66):
In Reply to: Re: Re: Re: cylinder ridge posted by Stan on January 22, 2003 at 14:49:30:
There is never enough money to do the job right but there is always enough to do it over a 2nd time.Almost every time I've tried to cut corners or do a cheapy fix it has returned to haunt me. Seems to happen to others too. This isn't a 1500 hr machine but some engine that ran until it quit due to old age and wear. There is going to be so much wear and taper in the bore that the rings will have to be gapped at bottom dead center. If gapped at top dead center they will be too tight and break at the bottom of the bore. You have it all apart, have to purchase rings and gaskets anyways. May as well take it the machine shop and have them hot tank and pressure test/crack check the castings.Then machine the mating surfaces flat. Put new valve guides, seats and valves in it too. Diesels loose too much compression when the valves are sunk. New guides and full size valve stems stop the wobbling and have the valve/seat meet squarely and seal. Otherwise the valve job is wasted and high oil consumption will also occur.
Follow Ups:
Home
| Forums
Today's Featured Article -
Restoration Story: 1951 Farmall H - by The Red (John Fritz). I have been a collector of Farmall tractors since 1990 when I first obtained part of the family farm in Eastern Indiana. My current collection includes a 1938 F20, 1945 H, 1946 H, and the recently purchased 1951 H. This article will focus on what I encountered and what I did to bring the 1951 NEAR DEATH Farmall H back to life.
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|