Tractor Talk Discussion Board |
Re: 1951 VAC
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Lew on January 22, 2003 at 20:34:52 from (207.190.81.60):
In Reply to: 1951 VAC posted by Dave L. on January 22, 2003 at 12:19:09:
Dave, I just measured my 1951 VAC with the hubs in the "normal" configuration and placed very near the end of the axle. 72" from outside of one tire to the outside of the other. I have never readjusted mine but they are movable if they are not chemically bonded by age to the axle. Some parts are cast iron so hammering is to be done gently. It appears if the fenders were off that the width could be shrunk to about 50". Hope this helped. Lew Van Vliet, Wisconsin. Yes it is cold out and I measured fast but my answer has no more than a 4% error margin. That's better than most polls.
Follow Ups:
Home
| Forums
Today's Featured Article -
The Tractor Parade: Story of a Case SC - by Bernie DeLon. On a early fall morning back in 1994, I opened the newspaper and happened to spy an article about a local antique tractor club having their annual show that weekend.
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|