Tractor Talk Discussion Board |
Re: Trailer Ramps
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Truck on January 21, 2003 at 09:07:46 from (205.188.209.109):
In Reply to: Trailer Ramps posted by BUDD on January 20, 2003 at 14:44:57:
An 18 foot bed that's 30 inches off the ground? Sounds like a candidate for a dovetail install. Just doing a "what looks right guess" I bet you will end up with ramps at least 5 feet long. Can you rough up a mockup with your current ramps enough to try it? Only problem with fold up ramps is occasionally one needs to carry something longer than what they will allow. If you can remove them and carry them somewhere else on the vehicle it can be helpful. One thing good about the foldups is you have the opportunity to create a stiff leg for loading that eliminates the need for blocking the trailer while loading. If you do that with yours your stifflegs will end up over two feet long. Make sure you get some reflective material on those so nobody runs into them!
Follow Ups:
Home
| Forums
Today's Featured Article -
The 8N and the Fox - by Zane Sherman. Dec. 13 1998, Renfroe, Alabama. Last niht I dreamed about the day that I plowed the field of about 10 acres over on what Jimmy and Dandy called the Ledbetter field. I was driving the 1948 8N Ford tractor that Jimmy bought in 48 new This was prebably in about 1951 and maybe even befor the house was built. This would have made me to be about16 years old and I drove the tractor for nothing and would have paid to drive it if I had had any money which I didn't, but neit
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|