Tractor Talk Discussion Board |
Re: tractor spliting/stands
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Stan on January 02, 2003 at 22:44:17 from (68.7.225.45):
In Reply to: tractor spliting/stands posted by tractor fan on January 02, 2003 at 18:28:41:
I posted about the same question a few days ago.I am about ready to split my JD 5020, which is over 100 hp. It was suggested not to relay on blocks to hold up the front. I made a very sturdy brace from 1"X5"X4ft.steel across the bottom of the front portion, and secured it to the side rails near the rear of the motor. I can now put a large screw jack on each side to support the front, or raise one side at a time if needed for reassembly. I still will put blocks under my support for extra safety. I am going to use a large floor jack to support the rear, and roll the back portion out.
Follow Ups:
Home
| Forums
Today's Featured Article -
Harvestin Hay: The Early Years (Part 2) - by Pat Browning. The summer of 1950 was the start of a new era in farming for our family. I was thirteen, and Kathy (my oldest sister) was seven. At this age, I believed tractor farming was the only way, hot stuff -- and given a chance I probably would have used the tractor, Dad's first, a 1936 Model "A" John Deere, to go bring in the cows! And I think Dad was ready for some automation too. And so it was that we acquired a good, used J. I. Case, wire tie hay baler. In addition to a person to drive th
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|