Tractor Talk Discussion Board |
Re: need info on JD horsedrawn gear assembly
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Willie on December 17, 2002 at 06:17:29 from (152.163.188.71):
In Reply to: need info on JD horsedrawn gear assembly posted by Brenda Heins on December 16, 2002 at 14:06:36:
Brenda Dusting the cobwebs from my mind, you probably are thinking about what we just called a "horse-power". Used it to drive grain elevator. Does it have a beam approx 10-12 feet long going out to the side? Hitch a team to it & horses walked in a circle. Output had approx 1 inch square. The one we had the shaft speed was too slow to drive anything like a sheller or grinder. My Dad added another pole to hook to horse's bit to keep them going in circle instead of going straight. My job as a kid was to walk behind them to keep them going. Last used it in 1956. Willie in Mn
Follow Ups:
Home
| Forums
Today's Featured Article -
Talk of the Town: Repairin a Gas Tank - by Staff. This interesting discussion is from the Tool Talk Discussion Forum. Remember that safety is your first priority - make sure you know what you are doing before attempting a potentially dangerous activity!
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|