Tractor Talk Discussion Board |
Re: What would you do??
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by david on December 11, 2002 at 15:35:33 from (64.12.96.236):
In Reply to: What would you do?? posted by 04terry on December 11, 2002 at 15:24:42:
I would not have taken delivery of the tractor, simply asked for a refund and looked elsewhere. Unfortunately, by accepting the tractor, and the JB Weld I'd say you're stuck. If you hadn't seen it and then taken the tractor home and found it might be grounds to return it and ask for a refund. Not too many options. You have the tractor, they have your check. If you stop the check after accepting the tractor, damage and all, they could prosecute you for theft by deception. I would call them, tell them that you are not satisfied (and never were), tell them that you are stopping the check and returning the tractor. If they say "sorry about your luck" you're stuck, but you are anyway. Wish this was better news. Your state (or their state, which if different would be the court of jurisdiction) may have different laws. DAB
Follow Ups:
Home
| Forums
Today's Featured Article -
Tractor Hydraulics - The Basics - by Curtis Von Fange. Hydraulics was one of the greatest inventions for helping man compound the work he can do. It’s amazing how a little floor jack can lift tons and tons of weight with just the flick of a handle. What’s even more amazing is that all the principals of hydraulic theory can be wrapped up in such a small package. This same package applies to any hydraulic system from the largest bulldozer to the oldest and smallest tractor. This short series will take a look at the basic layout of a simple hydraul
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|