|
Tractor Talk Discussion Board |
Re: Farmallmaniac
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Dennis Benson on December 05, 2002 at 10:34:09 from (152.163.188.71):
In Reply to: Farmallmaniac posted by Ryan ~farmallmaniac~ on December 04, 2002 at 19:28:44:
Hello, I didn't know if you wanted this all at once, or a little at a time. Do you have the head off the engine? If you have the head off the engine remove the ridge from the top of the cylinders with a ridge reamer. Then using first sandpaper, and second a deglazing hone in a drill remove rust from the cylinders, vacuum the powdered rust out. This is so that while you are working on loosening the pistons you won't be working against any extra rust. Then you can fill the cylinders with a few cups of penetrating oil in each cylinder and let it soak, and pound on each one a few times to see if they move. You might also have to sand rust from the cylinders from below the pistons. This will be a gradual proess, and can take days of soaking and hammering. Use a piece of wood on the piston and hammer on the wood to get the pistons moving. It might even help the penetrating oil to soak through better if you drain the water from the water jacket and fill the water jacket with boiling water while you are pounding. This will cause the cylinders to expand for a while and give more room for the penetrating oil to flow through, and will give more room for the rust that is between the pistons and cylinders to be able to roll and slide. If you are in freezing weather you will have to remove the water when you are done so it doesn't freeze.
Follow Ups:
Home
| Forums
Today's Featured Article -
Third Brush Generators - by Chris Pratt. While I love straightening sheet metal, cleaning, and painting old tractors, I use every excuse to avoid working on the on the electrics. I find the whole process sheer mystery. I have picked up and attempted to read every auto and farm electrics book with no improvement in the situation. They all seem to start with a chapter entitled "Theory of Electricity". After a few paragraphs I usually close the book and go back to banging out dents. A good friend and I were recently discussing our tractor electrical systems when he stated "I figure it all comes back to applying Ohms Law". At this point
... [Read Article]
Latest Ad:
John Deere B 1943
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|
