Tractor Talk Discussion Board |
Bearing Clearance
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Andy on December 03, 2002 at 05:54:23 from (66.19.76.183):
I had the crankshaft turned since I am rebuilding the CE engine on my B. When I put the gear back on the crank I heated it in the oven to 350 so it would go on the shaft. It went on but did not go all the way to the main bearing journal. It stopped just shy maybe .010 or .015 Now I have put the bearing halves in the block and I started with the thrust bearing after dropping the crank into the block. After shimming it to .002 it turns great without any play but it has .016 end play. My book says the end play should be .001-.005 My questions are: does the gear need to be tight against the journal and is there any other way to tighten the end play that I now have ? I know .015 will make it go knock, knock, knock..... Thanks, Andy
Follow Ups:
Home
| Forums
Today's Featured Article -
The Day Mom Drove the 8N - by Brian Browning. My Dad was wanting to put in a garden but couldn't operate the 8N and handle the old horse drawn plow he had found and rigged up to use with the tractor. Well, he decided to go get Mom out of the house and have her drive the tractor while he walked behind the plow. You got to understand that while my Mom is a hard worker who will always help whenever she can... she had never operated farm machinery before that day. Dad got her out there, explained how the clutch was the same as in our o
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|