Tractor Talk Discussion Board |
Re: Melting fuses
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Ben in KY on December 02, 2002 at 18:16:43 from (207.246.76.67):
In Reply to: Melting fuses posted by Paul (QC) on December 02, 2002 at 16:17:52:
Corrosion or a loose fuseholder sounds like it was probably your problem. I like to put a bit of no-ox electrical grease on the fuse connectors on all of my outside type of equipment. this helps to prevent corrosion and makes the fuses easy to pull if they do blow. In your case, once the fuse holders have done as your seem to have, the best long term solution is to replace the fuse holder. The heat has removed the tension from them. Of course I say I like to grease the fuse clips.... but I do not always do that and sometimes have the same problem as you. Ben in KY
Follow Ups:
Home
| Forums
Today's Featured Article -
Choosin, Mounting and Using a Bush Hog Type Mower - by Francis Robinson. Looking around at my new neighbors, most of whom are city raised and have recently acquired their first mini-farms of five to fifteen acres and also from reading questions ask at various discussion sites on the web it is frighteningly apparent that a great many guys (and a few gals) are learning by trial and error and mostly error how to use a very dangerous piece of farm equipment. It is also very apparent that these folks are getting a lot of very poor and often very dangerous advice fro
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|