Tractor Talk Discussion Board |
Re: Suggested Manufactories for Metal Buildings
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by BB on November 18, 2002 at 05:05:44 from (65.216.31.130):
In Reply to: Suggested Manufactories for Metal Buildings posted by Russ on November 15, 2002 at 09:51:47:
I put up a 30'x40' prefab metal building myself manufactured by Mueller Steel Buildings, but I believe they are only in Texas. It gets quite hot here also, average about 25 days over 100 degrees per year. My building is insulated and has a white roof. Even on the hottest days, the inside temp does not rise much if any above the outside temp. I put in a 10x10 door on each end. If I am working there in the summer, I just open both doors and the breeze blows thru. I put a large window AC unit thru the wall, but never use it unless I am doing outside work in the summer and need a place to go cool off.
Follow Ups:
Home
| Forums
Today's Featured Article -
Third Brush Generators - by Chris Pratt. While I love straightening sheet metal, cleaning, and painting old tractors, I use every excuse to avoid working on the on the electrics. I find the whole process sheer mystery. I have picked up and attempted to read every auto and farm electrics book with no improvement in the situation. They all seem to start with a chapter entitled "Theory of Electricity". After a few paragraphs I usually close the book and go back to banging out dents. A good friend and I were recently discussing our tractor electrical systems when he stated "I figure it all comes back to applying Ohms Law". At this point
... [Read Article]
Latest Ad:
John Deere B 1943
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|