Tractor Talk Discussion Board |
Re: One more pole barn concrete question..
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by ShepFL on October 24, 2002 at 17:54:41 from (63.175.91.20):
In Reply to: One more pole barn concrete question.. posted by Dave_D on October 24, 2002 at 09:00:50:
Not really a concrete man but I have been project manager for several new construction commercial warehouses. When uprights are poured in place or mounted to the surface they concrete fellas ALWAYS cut a diamond into the surface. This is generally about 3-4" wider than the pole itself. This acts a an expansion joint and if floor flexs it's effect is minimal on the uprights. Also, if the uprights move only a small area to repour vs. entire slab section. All slabs I have seen poured always have a plastic vapor barrier to retard moisture. FWIW
Follow Ups:
Home
| Forums
Today's Featured Article -
Ford N-Series Transmission/Hydraulic Fluid - The Full Story - by Llamas. The transmission fluid in an “N”:-series tractor lubricates the transmission, differential, rear wheel bearings, PTO and hydraulic pump drive, and it also cats as the working fluid for the hydraulic lift. In 9N/2N models, it also lubricates the steering sector and shaft system. The owner’s manual for the 9N and 2N models specified the use of only two fluids. They were STRAIGHT MINERAL OIL SAE 90 (above freezing) and
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|